Blackburn Lightset Combo 300 Front / 30 Rear USB

The Blackburn 300 Lumen Premium Bike Light Set is an ideal choice for riders who venture on dark trails or in low - to - zero light conditions. The high - power 300 Lumen headlight uses the latest lighting tech with advanced lens designs and reflector optics. Brighter LEDs illuminate the road ahead, and the secondary diffused beam makes you more visible to traffic and other cyclists. This light set is a breeze to install without any tools, thanks to the silicone straps that can fit almost any handlebar or seat post size. Both lights are USB rechargeable, and a micro - USB charging cable comes included. The headlight offers three modes and has a built - in power gauge, while the 30 Lumen Glow Tech(TM) tail light uses the latest COB (Chip on Board) technology with five different modes. Glow Tech(TM) COB technology packs LEDs closer together than regular LED lights, producing an ultra - bright glow. Key features include: a 300 Lumen headlight with advanced beam tech for a bright center beam to see and a wide outer beam to be seen; three headlight modes with run times of 1 hour on Steady Hi - Beam, 2 hours on Steady Lo - Beam, and 4 hours on Flashing; a 30 Lumen tail light with Glow Tech COB technology for a wide, ultra - bright beam; three tail light modes with run times of 13 hours on Steady Hi - Beam, 22 hours on Steady Lo - Beam, and 29 hours on Flashing; and USB recharging that eliminates the need to buy batteries.

Using your Blackburn bike light set is easy. First, install the lights on your bike. The silicone straps make it simple to attach the headlight to your handlebar and the tail light to your seat post without any tools. To turn on the lights, just press the button on each light. The headlight has three modes: Steady Hi - Beam, Steady Lo - Beam, and Flashing. You can cycle through these modes by pressing the button. The tail light also has multiple modes and you can switch between them in the same way. When it's time to charge the lights, use the included micro - USB charging cable. Just plug it into the light and a power source. Make sure to charge the lights fully before your next ride. As for maintenance, keep the lights clean by wiping them with a soft, dry cloth. Avoid getting the lights wet as much as possible, although they are designed to withstand some moisture. If you notice any damage to the lights or the charging cable, stop using them and contact customer support.